Move SDA/SCL pins into pins.h for fastio compatibility

fastio relies on macros for pin definitions, so we cannot use the const
declaration in Sd2PinMap or the arduino's definition.

Declare SDA/SCL_PIN into pins.h based on the current MCU, which is
identical in all our variants.

Remove the conflicting/unused declaration in Sd2PinMap.

Firmware/Sd2PinMap.h

@@ -37,10 +37,6 @@ struct pin_map_t {
 || defined(__AVR_ATmega2560__)
 // Mega
 
-// Two Wire (aka I2C) ports
-uint8_t const SDA_PIN = 20;  // D1
-uint8_t const SCL_PIN = 21;  // D0
-
 #undef MOSI_PIN
 #undef MISO_PIN
 // SPI port
@@ -365,4 +361,4 @@ static inline __attribute__((always_inline))
 #endif  // Sd2PinMap_h
 
 
-#endif
+#endif

Firmware/pins.h

@@ -25,6 +25,11 @@
 #error Unknown MOTHERBOARD value in configuration.h
 #endif
 
+#if !defined(SDA_PIN) && (defined(__AVR_ATmega1280__) || defined(__AVR_ATmega2560__))
+#define SDA_PIN 20
+#define SCL_PIN 21
+#endif
+
 //List of pins which to ignore when asked to change by gcode, 0 and 1 are RX and TX, do not mess with those!
 #define _E0_PINS E0_STEP_PIN, E0_DIR_PIN, E0_ENABLE_PIN, HEATER_0_PIN,
 #if EXTRUDERS > 1