|
@@ -147,7 +147,7 @@ After updating the kit, you may need to reload VScode.
|
|
|
|
|
|
|
|
#### Building
|
|
#### Building
|
|
|
|
|
|
|
|
-To start building a firmware, click the CMake Tools plugin icon on the far left side. You will get a very large list of targets to build. Find the firmware you'd like to build (like `MK3S-EINSy10a_ENGLISH`)and select the small icon which shows "Build" when hovered over.
|
|
|
|
|
|
|
+To start building a firmware, click the CMake Tools plugin icon on the far left side. You will get a very large list of targets to build. Find the firmware you'd like to build (like `MK3S-EINSy10a_ENGLISH`) and select the small icon which shows "Build" when hovered over.
|
|
|
|
|
|
|
|
The built .hex file can then be found in folder `Prusa-Firmware/build`
|
|
The built .hex file can then be found in folder `Prusa-Firmware/build`
|
|
|
|
|
|
|
@@ -187,10 +187,10 @@ Run "Arduino IDE", then
|
|
|
|
|
|
|
|
- Open the file `Firmware/Firmware.ino`
|
|
- Open the file `Firmware/Firmware.ino`
|
|
|
- Select the target board with Tools -> Board -> "PrusaResearch Einsy RAMBo"
|
|
- Select the target board with Tools -> Board -> "PrusaResearch Einsy RAMBo"
|
|
|
-- Open `Firmware/config.h` and change LANG_MODE to 0.
|
|
|
|
|
|
|
+- Open `Firmware/config.h` and change `LANG_MODE` to 0.
|
|
|
|
|
|
|
|
|
|
|
|
|
### Compilation and upload
|
|
### Compilation and upload
|
|
|
|
|
|
|
|
-- Run the compilation Sketch -> Verify/Compile
|
|
|
|
|
-- Upload the result code into the connected printer Sketch -> Upload
|
|
|
|
|
|
|
+- Run the compilation: Sketch -> Verify/Compile
|
|
|
|
|
+- Upload the result code into the connected printer: Sketch -> Upload
|
Yuri D'Elia