Rename check_fans>readFanTach manageFans>checkFans

Firmware/fancheck.cpp

@@ -219,7 +219,7 @@ void checkExtruderAutoFans()
 #endif // any extruder auto fan pins set
 
 #if (defined(FANCHECK) && defined(TACH_0) && (TACH_0 > -1))
-void check_fans() {
+void readFanTach() {
 #ifdef FAN_SOFT_PWM
     if (READ(TACH_0) != fan_state[0]) {
         if(fan_measuring) fan_edge_counter[0] ++;
@@ -238,7 +238,7 @@ void check_fans() {
 }
 #endif //TACH_0
 
-void manageFans()
+void checkFans()
 {
 #ifndef DEBUG_DISABLE_FANCHECK
 #if (defined(EXTRUDER_0_AUTO_FAN_PIN) && EXTRUDER_0_AUTO_FAN_PIN > -1)

Firmware/fancheck.h

@@ -13,7 +13,7 @@ enum {
 };
 extern volatile uint8_t fan_check_error;
 
-void check_fans();
+void readFanTach();
 #endif //(defined(TACH_0))
 
 #ifdef EXTRUDER_ALTFAN_DETECT
@@ -32,5 +32,5 @@ void setExtruderAutoFanState(uint8_t state);
 void checkExtruderAutoFans();
 #endif
 
-void manageFans();
+void checkFans();
 void hotendFanSetFullSpeed();

Firmware/temperature.cpp

@@ -550,7 +550,7 @@ void manage_heater()
     }
   } // End extruder for loop
 
-  manageFans();
+  checkFans();
 
   #ifndef PIDTEMPBED
   if(_millis() - previous_millis_bed_heater < BED_CHECK_INTERVAL)
@@ -1768,7 +1768,7 @@ FORCE_INLINE static void soft_pwm_isr()
   if (!SdFatUtil::test_stack_integrity()) stack_error();
 
 #if (defined(FANCHECK) && defined(TACH_0) && (TACH_0 > -1))
-  check_fans();
+  readFanTach();
 #endif //(defined(TACH_0))
 }