Change temp_runaway_timer from float to uint32_t

Saves 32 bytes of flash

Also change temp_runaway_error_counter from int to
uint16_t to be specific

Firmware/temperature.cpp

@@ -222,8 +222,8 @@ enum TempRunawayStates : uint8_t
 #if (defined (TEMP_RUNAWAY_BED_HYSTERESIS) && TEMP_RUNAWAY_BED_TIMEOUT > 0) || (defined (TEMP_RUNAWAY_EXTRUDER_HYSTERESIS) && TEMP_RUNAWAY_EXTRUDER_TIMEOUT > 0)
 static uint8_t temp_runaway_status[4];
 static float temp_runaway_target[4];
-static float temp_runaway_timer[4];
-static int temp_runaway_error_counter[4];
+static uint32_t temp_runaway_timer[4];
+static uint16_t temp_runaway_error_counter[4];
 
 static void temp_runaway_check(int _heater_id, float _target_temperature, float _current_temperature, float _output, bool _isbed);
 static void temp_runaway_stop(bool isPreheat, bool isBed);
@@ -1244,7 +1244,7 @@ void temp_runaway_check(int _heater_id, float _target_temperature, float _curren
 {
      float __delta;
 	float __hysteresis = 0;
-	int __timeout = 0;
+	uint16_t __timeout = 0;
 	bool temp_runaway_check_active = false;
 	static float __preheat_start[2] = { 0,0}; //currently just bed and one extruder
 	static int __preheat_counter[2] = { 0,0};