| 123456789101112131415161718192021222324252627282930 |
- MSG_BABYSTEP_X c=0 r=0 "Babystep X"
- MSG_BABYSTEP_Y c=0 r=0 "Babystep Y"
- MSG_CONFIRM_NOZZLE_CLEAN_FIL_ADJ c=20 r=8 "Filaments are now adjusted. Please clean the nozzle for calibration. Click when done."
- MSG_CONTROL c=0 r=0 "Control"
- MSG_CRASH_DETECTED2 c=20 r=2 "Crash detected. Continue printing?"
- MSG_FIL_ADJUSTING c=20 r=4 "Adjusting filaments. Please wait."
- MSG_FLOW0 c=0 r=0 "Flow 0"
- MSG_FLOW1 c=0 r=0 "Flow 1"
- MSG_FLOW2 c=0 r=0 "Flow 2"
- MSG_FW_VERSION_RC c=20 r=8 "This firmware version is release candidate. Some of the features may not work properly."
- MSG_INFO_FILAMENT_XDIFF c=11 r=1 "Fil. Xd:"
- MSG_INFO_FILAMENT_YDIFF c=11 r=1 "Fil. Ydiff:"
- MSG_LANGUAGE_NAME c=0 r=0 "English"
- MSG_LOAD_EPROM c=0 r=0 "Load memory"
- MSG_MOTION c=0 r=0 "Motion"
- MSG_REBOOT c=20 r=0 "Reboot the printer"
- MSG_RECTRACT c=0 r=0 "Rectract"
- MSG_RESTORE_FAILSAFE c=0 r=0 "Restore failsafe"
- MSG_SD_NOT_PRINTING c=0 r=0 "Not SD printing"
- MSG_SERIAL_ERROR_MENU_STRUCTURE c=0 r=0 "Error in menu structure"
- MSG_SET_HOME_OFFSETS c=0 r=0 "Set home offsets"
- MSG_SET_ORIGIN c=0 r=0 "Set origin"
- MSG_STEPPER_TIMER_OVERFLOW_ERROR c=20 r=4 "Error - stepper timer overflow"
- MSG_STORE_EPROM c=0 r=0 "Store memory"
- MSG_SWITCH_PS_OFF c=0 r=0 "Switch power off"
- MSG_SWITCH_PS_ON c=0 r=0 "Switch power on"
- MSG_TAKE_EFFECT c=20 r=0 " for take effect"
- MSG_USB_PRINTING c=0 r=0 "USB printing "
- MSG_VOLUMETRIC c=0 r=0 "Filament"
- MSG_VOLUMETRIC_ENABLED c=0 r=0 "E in mm3"
|
