PrusaFirmware/lang_upgrade/msgs_en_unused.txt

MSG_BABYSTEP_X c=0 r=0 "Babystep X"
MSG_BABYSTEP_Y c=0 r=0 "Babystep Y"
MSG_CONFIRM_NOZZLE_CLEAN_FIL_ADJ c=20 r=8 "Filaments are now adjusted. Please clean the nozzle for calibration. Click when done."
MSG_CONTROL c=0 r=0 "Control"
MSG_CRASH_DETECTED2 c=20 r=2 "Crash detected. Continue printing?"
MSG_FIL_ADJUSTING c=20 r=4 "Adjusting filaments. Please wait."
MSG_FLOW0 c=0 r=0 "Flow 0"
MSG_FLOW1 c=0 r=0 "Flow 1"
MSG_FLOW2 c=0 r=0 "Flow 2"
MSG_FW_VERSION_RC c=20 r=8 "This firmware version is release candidate. Some of the features may not work properly."
MSG_INFO_FILAMENT_XDIFF c=11 r=1 "Fil. Xd:"
MSG_INFO_FILAMENT_YDIFF c=11 r=1 "Fil. Ydiff:"
MSG_LANGUAGE_NAME c=0 r=0 "English"
MSG_LOAD_EPROM c=0 r=0 "Load memory"
MSG_MOTION c=0 r=0 "Motion"
MSG_REBOOT c=20 r=0 "Reboot the printer"
MSG_RECTRACT c=0 r=0 "Rectract"
MSG_RESTORE_FAILSAFE c=0 r=0 "Restore failsafe"
MSG_SD_NOT_PRINTING c=0 r=0 "Not SD printing"
MSG_SERIAL_ERROR_MENU_STRUCTURE c=0 r=0 "Error in menu structure"
MSG_SET_HOME_OFFSETS c=0 r=0 "Set home offsets"
MSG_SET_ORIGIN c=0 r=0 "Set origin"
MSG_STEPPER_TIMER_OVERFLOW_ERROR c=20 r=4 "Error - stepper timer overflow"
MSG_STORE_EPROM c=0 r=0 "Store memory"
MSG_SWITCH_PS_OFF c=0 r=0 "Switch power off"
MSG_SWITCH_PS_ON c=0 r=0 "Switch power on"
MSG_TAKE_EFFECT c=20 r=0 " for take effect"											
MSG_USB_PRINTING c=0 r=0 "USB printing  "
MSG_VOLUMETRIC c=0 r=0 "Filament"
MSG_VOLUMETRIC_ENABLED c=0 r=0 "E in mm3"