Mirror of official Prusa firmware with custom changes.

PavelSindler c03a18f8c3 czech messages added, temperature calibration is off in fresh eeprom, pinda preheat phase is not used unless calibration was run, pause print works with gcode absolute and relative extruder mode, move z higher after selftest		пре 8 година
ArduinoAddons	4e61ac2eb1 Different calibrate Z string and finally arduino addons added.	пре 8 година
Firmware	c03a18f8c3 czech messages added, temperature calibration is off in fresh eeprom, pinda preheat phase is not used unless calibration was run, pause print works with gcode absolute and relative extruder mode, move z higher after selftest	пре 8 година
LICENSE	a4a80b3eb7 MK2 Firmware release.	пре 8 година
README.md	053c727fed Bed MINTEMP implemented, MAXTEMP behaviour changed, loading filament bug fixed, Extruder max feedrate increased and Italian language strings fix.	пре 8 година

Original Prusa i3 MK2 Firmware

General instructions

Pre-compiled hex output on PRUSA RESEARCH site: http://prusa3d.com/downloads/firmware/

Just download and flash it to the electronics

Install arduino

Remove Liquid Crystal library from your arduino or rename it

Install the arduino addon located in the root of this repo. Don't forget to install correct version!

Copy the configuration file matching your printer from variants folder to the the Firmware folder

Rename it to "Configuration_prusa.h"

Compile the firmware

Upload the firmware to board